Staub-electronics H5085 VIVITEK - 1080P HOME THEATRE PROJECTOR (1800 Manuel d'utilisateur télécharger pdf (Page 3)

Projector Installation Notice

¾ Place the projector in a horizontal position

The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in

any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically.

¾ Allow at least 50 cm clearance around the exhaust vent.

¾ Ensure that the intake vents do not recycle hot air from the exhaust vent.

¾ When operating the projector in an enclosed space, ensure that the surrounding air temperature

within the enclosure does not exceed operating temperature while the projector is running, and the

air intake and exhaust vents are unobstructed.

¾ All enclosures should pass a certified thermal evaluation to ensure that the projector does not recycle

exhaust air, as this may cause the device to shutdown even if the enclosure temperature is with the

acceptable operating temperature range.

Power Safety

¾ Only use the supplied power cord.

¾ Do not place anything on the power cord. Place the power cord where it will not be in the way of foot

traffic.

¾ Remove the batteries from the remote control when storing or not in use for a prolonged period.

– iii –

1 2 3 4 5 6 7 8 ... 55 56

Pas de commentaire

Staub-electronics H5085 VIVITEK - 1080P HOME THEATRE PROJECTOR (1800 Manuel d'utilisateur Page 3