Staub-electronics MRX-2 URC - 2 WAY NETWORK BASE STATION WITH ADDITI Manuel d'utilisateur télécharger pdf (Page 8)

Rear

The rear panel ports are:

Power: Uses the included 12V/1Amp power supply.

LAN: Plug an ethernet cable (RJ45) to the LAN(Local Area network).

Relay NO, NC, COM: Configurable switch closure control.

RS-232 Ports: Two RS232 ports provide direct control.

Sensor: Connect with one of URC’s or compatible third party,

sensors.

IR IN:

Allows MRX-2 control from a base station such as a MRF-260.

Note:IR Routing is lost from commands received from this input.

IR Outputs: Connect emitters for IR control of connected devices.

RFTX Port: Dual port #6 for the RFTX-1 connecting cable or

included sleeved IR emitter.

RF IN: Connects to an optional single RFX-250 (Only for MX series

products.)

RF Out: Used for daisy chaining MRX-2s for RF Operation (Refer to

the RFX-250 manual.)

RF ID: 15 unique RF ID's provide RF control and routing to multiple

MRX-2’s in the same home.

Note: DO NOT USE RF ID #0, as it is the interference "sniffer", used

to detect RF interference in the area.

Page 5

Ethernet

Power

Relay:NO,

NC, COM

RS-232 Ports

Sensor

IR IN

IR Outputs: #1-6

RFTX Port: #6

RF IN

RF Out

RF ID

MRX-2 NETWORK BASE STATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Staub-electronics MRX-2 URC - 2 WAY NETWORK BASE STATION WITH ADDITI Manuel d'utilisateur Page 8